-
Oliver 166-BD 12" Jointer
- .
- s/n #63787
- Built in
1946
-
-
-
-
-
5 HP, 220 volt, 3 phase, 3 knife
head, 99 inch bed
This machine is rebuilt to the
highest standard both mechanically and cosmetically. It features updated motor
controls and will perform like new. Some of its features are as follows:
 | Entire machine was cleaned,
filled, primed and painted with 2 coats of Sherwin Williams Industrial Enamel
in Oliver teal. |
| Infeed and outfeed tables were
surface ground to factory tolerance of .001 per foot |
| Shoes remachined (inclines for
table) |
| Motor disassembled, cleaned and
checked by a motor specialist |
| New SKF motor bearings |
| Head rebalanced for 3600 RPM |
| Head run out .0004, gibs balanced
to .2 grams |
| New knives |
| Front and rear guard powder coated
red |
| Allen Bradley magnetic starter
with lockable service disconnect, stop start station located near brake lever |
| Table elevation locks changed to
later style (less backlash) |
| Fence face surface reground flat |
| 2 additional locks were added to
fence to keep it from drifting off the desired angle |
| The fence can be shifted off 90
degrees and returned to the 90 degree stop within 0 degrees 1 minute every
time |
| Custom made heavy duty leveling
feet (not shown) |
